Description
Trailers can carry a maximum weight of 20,000kg. They can accommodate either 8-Tonne, 10-Tonne, 14-Tonne Drum Stands. The Drum Stands can be provided with most of the accessories listed under their appropriate Drum Stand size sections of this website. Depending on the requirements of the customer they can be provided with 500kg or 1,000kg at 1m diameter drum rotators. These Drum Stand trailers are designed to drop cable into open trenches so they can be provided with additional toe coupling at the back making it possible to couple a 3-Tonne trailer for handling fibre optic cable. If the requirement is for larger drums of fibre optic cable, then a second trailer will have to be towed behind. Drum Stand trailers can be provided with a range of optional equipment including cable feed systems, spreader bars and associated lifting equipment, pendant or radio remote controls. All trailers are manufactured in such a way that even with optional cable feeders they are ADR approved and can be driven on public roadways.
Specification
Maximum Drum Mass: 8,000kg, 10,000kg, 14,000kg
Maximum Drum Diameter: 3,200mm
Maximum Drum Width: 1,700mm
Spindle Diameter: 95mm
All Drum Stands are hot tip galvanized and all spindle hardware is zinc plated and gold passivated. The hydraulic disc brake is manufactured from stainless steel and the power pack enclosure is powdercoated. There is lifting lugs provided at all four corners of the Drum Stand. Drums Stands are attached to the trailer via four container locks. The drum shank can be separated from the trailer and can be used as an independent unit. The hydraulic power pack includes water cooled diesel engine and suitable hydraulic valving and filtration system suitable to operate in harsh environments. The hydraulic power pack has a noise rating of 85dBA or less.
Parts Books & Operating Instructions
The equipment is supplied with one copy of an operation manual which includes operating instructions, safety information, major assembly drawings, hydraulic and electrical schematics (if applicable), etc. Additional copies are available upon request at nominal cost.
Change in Specification
Design and improvement of products is a continuous process. We, therefore reserve the right to make design improvements differing from this specification after receipt of an order. However, any major changes will only be made with the approval of the customer or its’ representatives.
Warranty
12 months parts and labour in accordance with guarantee and sales conditions.
Options
Option 1
Single 8-Tonne, 10-tonne, 14-tonne Drum Stand
Including
– Stainless steel disc brake assembly
– 95mm spindle assembly,
– Integral diesel/hydraulic power pack and valving
– 500 kg line pull drum rotator assembly.
Option 2
Single 8-Tonne, 10-tonne, 14-tonne Drum Stand
Including
– Stainless steel disc brake assembly
– 95mm spindle assembly,
– Integral diesel/hydraulic power pack and valving
– 1000 kg line pull drum rotator assembly.
Option 3
Spreader bar and chain assembly for lifting drums in and out of stand
Option 4
Additional 8000 kg spindle
Option 5
Hydraulic hand pump assembly for greater brake control.
Option 6
Cable feeder system, (roller mechanism from cable drum to trench)
Option 7
Cable feed system to operate on both sides of the trailer
Option 8
Supply suitable tow-coupling to the rear of the trailer
Option 9
Non Standard Additions: Trailer
Consisting of:
– One Chassis
– 2 x 15 inch axles – 225 PCD
– Air suspension
– 2 speed manual wind down leg
– 9 x 215/75 – 17.5 tubeless tyres and steel rims
– 1 x spare tyre carrier
– Hub meter
– ADR approved braking
– Chassis sandblasted & grey primer + 2 coats 2 pack paint.
